Updated November 2026

A dehumidifier that smells like mildew usually has a damp, dirty interior that is growing microbes, and the fix is almost always a thorough cleaning followed by better habits. This guide shows you how to find the source of the smell, clean the parts that hold moisture, and keep the unit from smelling musty again. Most people can get the odor under control in under an hour.

Find Where the Smell Is Coming From

Before you clean anything, figure out which part of the unit is causing the odor. The smell often comes from one of three places: the water bucket, the air filter, or the evaporator coil behind the front grille. Sniff near the air outlet and then near the bucket. A strong, sour smell near the outlet usually points to the coil or the filter, while a smell that rises when you lift the bucket points to standing water.

Shopping for one? See our guide: Dehumidifier for Mildew Smell: 6 Best Picks Compared (2026).

Also check the room itself. If the unit sits in a basement or closet with its own mildew problem, the dehumidifier may simply be pulling in and exhausting that odor. Check whether the smell is strongest when the unit is running and whether it fades when it is off.

Clean the Water Tank and Drain Path

Standing water is the most common cause of a mildew smell. Empty the bucket every day or two, or connect a drain hose if your model supports continuous drainage. Wipe the inside of the tank with a solution of one part white vinegar to three parts water, then rinse it well. Scrub the float switch and the corners where slime collects.

  1. Unplug the unit and remove the water bucket.
  2. Wash the bucket with warm water and a small amount of mild dish soap.
  3. Wipe the bucket and tank interior with the vinegar solution.
  4. Rinse thoroughly so no vinegar smell or residue remains.
  5. Dry the bucket completely before reinstalling it.

Clean the Air Filter and Evaporator Coil

The air filter traps dust, pet hair and skin cells. When it stays damp, those particles turn into a food source for mold and bacteria. Remove the filter and rinse it under lukewarm water, then let it air dry fully. Most manufacturers say to clean filters every two to four weeks, and to replace them when they tear or no longer clean well.

The evaporator coil is harder to reach but often the real source. Use a soft brush or a vacuum with a brush attachment to remove dust from the fins. For a deeper clean, use a coil cleaner or a diluted mild detergent and a soft brush, following the manufacturer’s instructions. Never use harsh chemicals that could damage the coil or leave fumes. If the smell persists after cleaning, consult a qualified appliance technician, since the coil may need professional service.

Let the Unit Dry Out Between Uses

Once cleaning is done, run the dehumidifier on its normal setting for a few hours with the bucket out, then check the interior for any remaining moisture. Leaving the unit wet between cycles is one of the fastest ways to bring the smell back.

Prevent the Smell From Coming Back

Keep the room humidity at or below about 50 percent, since levels above that give mold a foothold. A basic hygrometer will show you what the room is actually doing. Also make sure the unit has at least the clearance the manufacturer specifies on all sides so air can move freely, and avoid placing it in a tight corner where moisture stays trapped.

Match the Unit to the Room

An undersized unit runs constantly and never fully dries the air, which keeps the interior damp. Check the rated capacity and compare it to your room’s size and moisture load. If you are unsure, Dehumidifier for Mold in Basement: 5 Best Picks Compared (2026) covers sizing for damp lower levels.

Common Mistakes

  • Leaving water in the bucket for days, which lets slime build up quickly.
  • Putting the filter back in while it is still damp.
  • Using bleach or strong cleaners, which can damage parts and leave harsh fumes.
  • Cleaning only the bucket and ignoring the coil and filter.
  • Running the unit in a sealed room where humidity cannot be exhausted properly.
  • Soft-bristle cleaning brush: Reaches the coil fins and tank corners without scratching surfaces. View on Amazon
  • Digital hygrometer: Shows the actual humidity so you can set the unit correctly and catch problems early. View on Amazon
  • Dehumidifier coil cleaner: A formulated cleaner for removing biofilm from the coil without the risks of household bleach. View on Amazon

For broader options, see Best Dehumidifiers and Dehumidifier to Remove Mold: How to Dry Out Your Home and Stop Regrowth, which cover drying out a damp space in more depth.

FAQ

Is a mildew smell from a dehumidifier dangerous?

The smell itself is a sign of microbial growth inside the unit, and it can be unpleasant or irritating for some people. If anyone in the home has asthma, allergies or a respiratory condition and symptoms worsen, consult a doctor or an allergist.

How often should I clean my dehumidifier?

Empty the bucket every day or two, clean the filter every two to four weeks, and wipe the tank monthly. Check your manual, since schedules vary by model.

Can I use bleach to get rid of the smell?

It is better to avoid bleach. It can corrode components and leave fumes, so use a mild vinegar solution or a coil cleaner made for appliances and rinse well.

Conclusion

A dehumidifier that smells like mildew almost always needs its tank, filter and coil cleaned and fully dried. Make cleaning a regular habit, keep humidity near 50 percent, and let the unit dry between cycles. If the smell returns after a thorough cleaning, a technician should inspect the unit.

Graham Fisher

About Graham Fisher

Graham Fisher is part of our editorial team and reviews and edits our indoor air guides, checking product details against manufacturer specifications and owner feedback.